WARNING:
This product can expose you to a chemical or chemicals such as Talc, which is known to the State of California to cause cancer, birth defects and/or reproductive harm. For more information go to www.P65Warnings.ca.gov
|
1984-1995 Pickup 2WD 5 Lug Pro Series 5" Over Kit |
|
- Race proven long travel performance suspension system.
- 5" extended boxed/plated lower arms bolt to the factory control arm mounting locations.
- 5" extended 4130 chromoly tubing upper control arms feature heim pivots for full adjustability of camber and caster. TC supplies a set up tool to ease installation that will bolt to the factory cross shaft mount and locate upper control arm tabs.
- Upper and lower ball joints are replaced with 1" uniballs for maximum wheel travel and component strength.
- TOTAL CHAOS includes 1" I.D. uniballs that feature a heat treated stainless steel ball & heat treated stainless steel race for maximum corrosion resistance and component longevity. These uniball's also features a military grade PTFE woven fabric liner that helps prevent noise.
- 3.5" TC custom modified 6 lug Toyota lift spindles provide a larger wheel bearing for added strength and are designed to offer maximum ground clearance at full bottom out.
- TC supplies a complete King Kong Steering system with this race kit. A custom fabricated centerlink and fully rebuild able idler arm uses a TC modified factory pitman arm. 3/4" heim tie rods are also included.
- Lower tubular/boxed control arms are designed with internal gussets and are pre tabbed for 10" travel inline 2.5" coil over and 3.0" bypass shocks.
- Heim pivot upper control arms feature 7/8" heims and are fully adjustable.
- Spring rate options allow the ability to customize your ride for your specific application. Maximize tune ability, articulation and performance.
- TC's bolt on strut frame adds strength to the front frame and cross member. Skid plate tabs are included.
- Stainless steel DOT braided brake lines, TC custom 17-4 stainless hi-misalignment spacers and all grade 8 mounting hardware is included.
- 2 stage powder coat process includes a durable clear coat to provide a long lasting finish.
- Hand crafted in the U.S.A.
- Custom upper shock mounts must be fabricated to install this kit.
- This kit requires 4wd Toyota hubs bearings & brakes for installation. (not included)
- These parts are only available directly from TOTAL CHAOS Fabrication Inc, please contact us at the shop for more information.
LIFT: 5-6" |
TRAVEL: 15" |
TIRE: 35" |
TRACK WIDTH INCREASE: 10" |
| |
Photos |
|
|
|
|